Welcome to Shenzhen Grande Electronic Co., Ltd.!

Shenzhen Grande Electronic Linkedin Page

E-mail us for a Quote:
sales88@greattong.com

Call us now:
+86-755-83261869

PCB Assembly: The Future of Embedded Passive Components

2017-07-19

Embedded passive components are likely to be an important innovation in electronic design in the near future. The primary benefits of these components is that they may cost less, and take up less space.

PCB Assembly: SMD IC Chips

2017-07-17

SMD Chips or ICs are not as easy to solder as SMD or through-hole components since alignment of SMD IC pins on PCB pads is extremely difficult because of the very fine pitch of these IC pins.

PCB Design: What is a Ball Grid Array?

2017-07-14

TheconventionalICpackagesthatusepins(suchasquadflatpackage)areentirelydifferentifcomparedtotherelativelynewerBGA(BallGridArray)package.BGAgetsitsnamefromthearrangement

Typical RoHS Issues in PCB Assembly

2017-07-13

Shenzhen Grande Electronics has significant expertise in Prototype PCB Assembly with turn times as quick as 24 hours. Any component ranging from simple DIP resistors to BGA components with more than 1700 ball solder joints can be inserted on all available

PCB Layout and Assembly

2017-07-12

The first step in any design is creating the circuit diagram. Once the circuit diagram is finalized, PCB design and layout phase starts. Any circuit is designed on paper or in circuit design software to be easily understandable but the PCB design doesn’t

PCB layout: What are layers related to PCB?

2017-07-10

The physical layers hold the actual PC circuit traces in copper conductors. Physical layers are separated by thin layers of insulation called substrate or prepreg.

Panelizing PCBs with Tab Routing

2017-07-07

Tab routing is a popular PCB panelizing approach that uses tabs with or without perforations. If you are separating the panelized PCBs manually, you should use the perforated type. If you feel that breaking the PCB off the panel would cause too much stres

PCB Assembly: How to Minimize NRE Costs

2017-07-05

he NRE charge on your turnkey PCB assembly quote accounts for the cost of services such as the programming of Pick & Place, Reflow Soldering, and Inspection machines, as well as the creation of solder stencils and electrical test beds for your particu

Multi-Layer PCB: Stack-Ups and Basics

2017-07-04

The particular requirements of track heights and material thickness for the production of a multi-layered Printed Circuit Board (PCB) is termed as Stack-Up. This Stack-Up is shown on the PCB fabrication drawings where a cross-sectional view shows the copp

PCB Fabrication: Minimum Thickness PCB

2017-07-03

Minimum thickness PCB means the thickness of the printed circuit board is thinner than normal PCB. The minimum thickness is 0.2 mm for the majority of the circuit boards. But at times, limited space or margin or due to need of the design, there is a deman

First - Previous -65 666768 69 70 71 72 73 74 - Next - End

Home About Us Services Quality Pb-Free News Contact Us

Copyright ® 2017,Shenzhen Grande Electronic Co., Ltd. All Rights Reserved. English 中文站 Sitemap